Draw the cord until the right hand carrier 1 is as far to the right as possible.
Cord drawn curtain tracks instructions.
3 unhook cord from master carrier and allow to drop inside track.
Curtain track features and how to install.
Installing your styletrack curtain track.
To drill holes identify where the holes should be positioned and mark the track.
How to fit new cord to curtain tracks take measurements.
First you ll want to remove the curtain along with the curtain hooks from the rod and carriers.
Next place the rod face down on a flat surface.
Tension cord and tie off h.
Then remove master carrier from the track.
Once you have worked out were your track is going to go.
8conversion to one way draw right hand conversion drapes drawn from left to right 1 lay track face down on the floor.
Add those two.
How to thread cord on curtain rails.
If unable to locate a timber stud use a suitable wall plug or toggle for hollow walls to hold your bracket.
Cord on overlap master carrier as original.
Place pulley 2 onto track section and secure with screws.
If you re removing an old cord you can untie it.
Remove the curtain rod from the.
Replace sliders at each end.
Standard drill bits work fine on all aluminum tracks.
2 pull track apart at the centre.
Pass the cord over the central bridge on slave master slide f twist cord to create a loop and hook over centre tab f pass cord over the top of the bottom pulley in opposite end pulley.
Hook cord over the lug on carrier 2 to secure it.
Holding the cords taut push carrier 2 as far to the left as possible.
Fitting instructions for styletrack track if installing into plaster or wallboard where possible try and pick up a timber stud.
Re attach track onto brackets and re hang curtains.
Click here for how to mend it.
Remove the curtains from the traverse rods so you can access the cording.
Most curtain tracks do not have the mounting holes pre drilled.
Measure also the distance from the floor to the top of the curtain rod.
Measure the rod s length while it is still on the wall.